Cyclone 3DR Wall Flatness and Wall Verticality Workflow.
In this Cyclone 3DR workflow demonstration we will be performing a wall flatness and verticality analysis on a section of brick wall.
SMART PLAN
Category / Cyclone 3DR
Cyclone 3DR is used for meshing point clouds and analysis.
Cyclone 3DR – Tank Meshing Example
In this example, we’ll be calculating the approximate volume from an incomplete, exterior scan of a large storage tank. After an initial cleaning of the tank points, we’ll extract a best fit cylinder and then refine it using the point cloud to get a better […]
Graphics Settings Required for Leica Geosystems Programs
Required Graphics Setting that need to be set manually for all programs.
CLM Installation v2.7.x Embedded Help Videos
Installation of the Client License Manager (CLM) program is required to use Leica Geosystems programs. After installing the CLM program, make sure you are connected to the internet, open the CLM program, and activate your EID numbers for your software programs. A green bar indicates […]
Creating Strapping Tables for Tanks in Cyclone 3DR – Virtual Class Recording
During this 20 minute Virtual Class Recording, Kriss Myer steps the user through the workflow of creating strappping tables for tanks in Cyclone 3DR. The class covers cleaning noise on the tank, meshing, setting a UCS and creating the strapping tables. Click the link below […]
Tunnel Volume in Cyclone 3DR – Virtual Class Recording
During this 20 minute Virtual Class Recording, Kriss Myer steps the user through the workflow of calculating the volume of a tunnel in Cyclone 3DR. The class covers creating and editing the mesh, filling in holes and capping it to create a water tight mesh. […]
Tunnel Analysis in Cyclone 3DR
The tunnel analysis tool is an excellent application to create cross sections and compare it to a designed model.
Tank Inspection/Analysis Routine in Cyclone 3DR
The tank module is dedicated to analysis on above ground tanks with vertical cylinder design, single shell with or without a roof.