This topic covers how to use all the features in REGISTER360 including import data, registration, and deliverables.
Learn how to import data collected on a RTC360 scanner using VIS and see the benefit of the onboard GPS with SiteMaps in the video by Brian Elbe This video also covers: Basic versus Advanced mode of reporting registration information Bundles Links Setup Clouds TruSlicer […]
Watch the following video by Brian Elbe to learn the basics of REGISTER 360 including adjusting the Settings and managing Projects and Storage.
Using Multiple SiteMaps in REGISTER 360 is a great way to separate data into smaller groups. Data registered in one bundle can be separated into separate SiteMaps and links can be created to navigate between them in TruView. Multiple SiteMaps is also a great tool […]
Installation of the Client License Manager (CLM) program is required to use Leica Geosystems programs. After installing the CLM program, make sure you are connected to the internet, open the CLM program, and activate your EID numbers for your software programs. A green bar indicates […]
There are a couple of ways to validate that your BLK360 is operating accurately. Remember it is always recommended to send in your instrument annually to the Leica Geosystems Service Center for calibration. Calibration Field Check Of the two tests that can be done, the […]
The FTCoE has previously produced reports that outlined selection and basic operation of laser scanners for forensic applications. These recommendations were foundational outlines of recommended practices to be incorporated into scanning workflows. The March 2022 FTCoE report is updated and includes technical definitions and revised […]
This self-guided Teachable class shows users how to import, verify and process point cloud data in REGISTER 360. It also highlights some of the basic tool sets in the program.
Workflow video covering the import of data captured on a BLK360 scanner using Cyclone Field 360 Tablet and importing the data to Register 360. Basic StepsCyclone Field 360 – Sync Server and get IP Address Register 360 – Create a project, select Field 360 import […]
The following workflow videos shows how to manage multiple control files in a single project in REGISTER 360. It covers minimum requirements for targets, how to edit control files and create virtual targets.
1:54 Minute Virtual Class Recording done with Ken Jones Instructing on Register 360 setup, data management, visual alignment, TruSlicer QA, and Limit Box use to clean out noise recorded on 8/24/2021
